Control engineering

Control Engineering is the design of systems capable of accurately controlling a physical device. Control engineering is traditionally considered a sub-field of Electrical Engineering.

The role of a control system is to translate a high level command into a one or more low level commands to achieve a desired system state. In response to a desired state (or command), a controller calculates a control signal which affects the operation of some actuator, which in turn affects the state of the system (or plant). Open loop control systems calculate the control signal using only the command, and perhaps an assumption about the state of the system. In contrast, a closed loop control system takes measurements of the state of the system. This feedback allows a control system to better control the system.

Examples of Control Engineering

• Toaster. A human operator was to make toast. The human operator inserts the toast and pushes a start button. The toaster heats the toast until a timer expires. However, the toaster cannot guarantee the color of the toast---only that this period of time usually gets the desired color. This is an example of an open loop control system. If, on the other hand, the toaster could observe toast color, a better control system could be designed to achieve ideal toast color.
• Thermostat. A human operator specifes a desired room temperature. The thermostat measures the actual room temperature and calculates an error signal in temperature. The thermostat then calculates a control signal using the error in temperature, as well as the history of the error signal and the control signal. The control signal connects to the heating and cooling hardware to affect this change. This is an example of a closed loop control system, because it incorporates feedback in the form of temperature measurement.
• Cruise Control. A human operator specifies a desired velocity for her automobile. The cruise control system measures current velocity and acceleration, and computes an amount of gas to inject into the engine (the control signal) to achieve the desired velocity. This is another example of a closed loop control system.
• Manufacturing. A robotic arm must pick up a part at one end of a factory, and carry it to the other end. The arm is mounted on a linear rail, and is capable of moving in either direction along that rail. At the two positions of interest, limit switches are installed. These switches produce a boolean signal (either true or false) which indicates that the arm is at one of those two positions or somewhere in between. The controller is a simple finite state machine, with a certain operation defined if the arm is at the first position, the second, or somewhere in between going towards one or the other.